10-29-2009, 07:20 PM
|
|
Ace Pilot
|
|
Join Date: Jul 2007
Location: Azores Portugal
Posts: 199
|
|
|
What is the prefered method of tightening the tail drive belt?
1. Loosen the boom support bolts and pull the boom back to tighten the belt
or
2. Loosen the tail case and pull it back to tighten the belt
Which is the best method?
Ted
Ted Schubert
I always have fun. Some times are more fun than others.
I can't remember half the crap I forgot.
Align TREX 600 CF/Spectrum DX 7 TX/ AR 7000 RX/Align RCM-BL600XL Motor/Align RCE-B3X BEC/Align RCE-BL7G Speed Controller/Futaba S9252/Logiteck LTG-6100T w/ Servo
Align Trex 450 SEV2/AR6000/Scorpion Commander 45A ESC
Scorpion HK 2221-8 Motor/GY 401 Gyro/HiTec HS65MG Servos
|
10-29-2009, 07:41 PM
|
 |
Moderator
|
|
Join Date: Jul 2007
Location: The Twilight Zone
Posts: 1,965
|
|
|
For me if the tail servo is mounted on the boom I would loosen the bolts on the boom block and Stabillizer mount pull the boom back to tighten the belt.
 LAKERS back 2 back CHAMPIONS
Last edited by DVS : 10-29-2009 at 08:16 PM.
|
10-29-2009, 08:13 PM
|
 |
Ace Pilot
|
|
Join Date: May 2006
Location: A Small Town in Western New York
Posts: 2,149
|
|
|
Don't loosen the tail case and pull it back. Loosen the frame screws as DVS says, and the support/horizontal fin mounting screws that clamp around the boom and pull it back out of the frame to tighten the belt.
Some tail cases have guides/detents/ribs that the boom slides into to keep it from rotating so the boom should be in the tail case as far as you can get it. If you start pulling it out and it gets past the guide/detent/rib you might have other problems down the road.
Nobody realizes that some people expend tremendous energy merely to be normal. - Albert Camus
|
10-29-2009, 11:11 PM
|
 |
Ace Hardware
|
|
Join Date: Jun 2006
Location: Pittston, Pa.
Posts: 5,933
|
|
|
Leave the tail case alone. Adjust from the frame side as DVS and kc posted.
I am NOBAR
|
10-29-2009, 11:20 PM
|
|
Ace Pilot
|
|
Join Date: Mar 2007
Location: SoCal
Posts: 994
|
|
Quote:
|
Originally Posted by heli-cuzz
Leave the tail case alone. Adjust from the frame side as DVS and kc posted.
|
......Yup.
Trex 450FBL, Vibe 90, Evo 50FBL & Freya 90/D3 Head
|
Linear Mode
